How To Regrout Tile Floor

Regrouting a tile floor is a relatively simple task that can be completed in a few hours. By following these steps, you can achieve a professional-looking finish that will last for years to come.

Materials You'll Need:

Grout
Grout float
Bucket
Sponge
Caulk gun
Caulk
Grout sealer

Step 1: Remove the Old Grout

Using a grout saw or a utility knife, carefully remove the old grout from the joints between the tiles. Be sure to remove all of the old grout, as any remaining grout will prevent the new grout from adhering properly.

Step 2: Clean the Joints

Once the old grout has been removed, use a sponge and clean water to clean the joints between the tiles. Be sure to remove all of the dust and debris from the joints.

Step 3: Mix the Grout

In a bucket, mix the grout according to the manufacturer's instructions. The grout should be mixed to a thick, creamy consistency.

Step 4: Apply the Grout

Using a grout float, apply the grout to the joints between the tiles. Be sure to press the grout firmly into the joints, and to fill the joints completely.

Step 5: Remove Excess Grout

Once the grout has been applied, use a damp sponge to remove any excess grout from the surface of the tiles. Be sure to rinse the sponge frequently to prevent the grout from hardening on the sponge.

Step 6: Let the Grout Dry

Allow the grout to dry completely before walking on the floor or sealing the grout. The drying time will vary depending on the type of grout used.

Step 7: Seal the Grout

Once the grout has dried completely, apply a grout sealer to the grout to protect it from stains and moisture. Be sure to follow the manufacturer's instructions for applying the grout sealer.

By following these steps, you can regrout your tile floor with ease. With a little bit of time and effort, you can achieve a professional-looking finish that will last for years to come.