How To Put In New Flooring

Installing new flooring is a great way to update the look of your home and increase its value. However, it can also be a daunting task, especially if you’ve never done it before. That’s why we’ve put together this comprehensive guide to help you through every step of the way.

Before you begin, it’s crucial to gather all the necessary tools and materials. These usually include a measuring tape, a utility knife, a flooring saw, a hammer, a nail set, a pry bar, a level, and a broom or vacuum cleaner. You’ll also want to choose the right flooring material for your space and flooring underlayment to add comfort and insulation to your floor.

The first step in installing new flooring is to prepare the subfloor. This can be done by removing any old flooring and debris, leveling the subfloor if necessary, and repairing any damaged areas.

Once the subfloor is prepared, you can begin installing the new flooring. The specific installation method will vary depending on the type of flooring you’ve chosen. However, there are some general steps that apply to most flooring types.

Installing Laminate Flooring

1. Start by measuring the room and determining how many planks you’ll need.
2. Cut the planks to size using a flooring saw.
3. Apply a bead of glue to the bottom of the first plank and place it in the corner of the room.
4. Continue adding planks by snapping them together along the sides and ends.
5. Use a pry bar to gently tap the planks into place.
6. Continue installing the planks until the entire room is covered.

Installing Vinyl Flooring

1. Start by measuring the room and determining how much vinyl you’ll need.
2. Cut the vinyl to size using a utility knife.
3. Peel back the backing of the vinyl and apply it to the subfloor.
4. Use a smoothing tool to smooth out the vinyl and remove any air bubbles.
5. Continue installing the vinyl until the entire room is covered.

Installing Hardwood Flooring

1. Start by measuring the room and determining how many planks you’ll need.
2. Cut the planks to size using a flooring saw.
3. Nail the planks to the subfloor using a flooring nailer.
4. Continue installing the planks until the entire room is covered.
5. Sand and finish the hardwood floor according to the manufacturer’s instructions.

Finishing Up

Once you’ve installed the new flooring, you may need to trim it around the edges of the room. You can do this using a utility knife or a flooring saw. Finally, clean up the area and enjoy your new floor!